IP (IPv4 and IPv6) settings¶

Here you can configure IPv4 or IPv6 settings on all available network adapters as well as add up to 10 static routes.

If an interface and protocol should not be used, enter "disabled" and if automatic configuration (RA for IPv6 and DHCP or IPv4) is required, enter "auto".

IPv4 and IPv6 address

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
    link/ether 08:00:27:6b:e8:2f brd ff:ff:ff:ff:ff:ff
    inet 151.217.182.21/24 brd 151.217.182.255 scope global eth0
    inet6 2001:67c:20a1:1182:b914:6548:2915:3e5c/64 scope global temporary dynamic
       valid_lft 3533sec preferred_lft 233sec
    inet6 2001:67c:20a1:1182:a00:27ff:fe6b:e82f/64 scope global dynamic
       valid_lft 3533sec preferred_lft 233sec
    inet6 fe80::a00:27ff:fe6b:e82f/64 scope link
       valid_lft forever preferred_lft forever

eth0: IPv4 address (auto or disabled, Q to quit)? <151.217.182.21>: auto
eth0: IPv6 address (auto or disabled, Q to quit)? <2001:67c:20a1:1182:a00:27ff:fe6b:e82f>: auto

Add static routes? (y/<N>):

IPv4 Configuration
eth0: Auto configuration via DHCP

IPv6 Configuration
eth0: Auto configuration via Router Advertisment

Write the above configuration to disk? (<Y>/n):

A reboot is required to activate the changes.